This brass cryogenic relief valve is a spring reference over pressure protection device. The CRV incorporates Generant’s exclusive “Dirt Guard” feature which increases the valves ability to tolerate particulate contamination. Relief pressure can be discharged to atmosphere or to a downstream connection.

A compact, highly accurate, direct acting, factory pre-set pressure relief valve. Available as a vent to atmosphere or as an inline configuration.  Factory preset to desired crack pressure and/or flow specifications.

This pressure control/relief valve was designed for use on DOT 4L cryogenic liquid cylinders. The LCV dramatically reduces the noise associated with traditional cylinder relief device discharge and optimises cylinder performance by venting only what is required to maintain cylinder pressure.

A brass pressure regulators that provide high flow and quick, positive shut off at the desired set pressure. The regulator design is a non-balanced, spring reference, pressure reducing type regulator designed for use on cryogenic liquid cylinders and many other applications.

This brass combo pressure build-economizer regulators offer optimum performance for cryogenic liquid cylinders. The regulators are designed for fast pressure building, steady head pressure during all use conditions, and maximum efficiency economization when cylinder pressure is near relief valve setting.

A brass back pressure range of regulators designed for use as both economizers or diaphragm type pressure limiting devices on cryogenic liquid cylinders and systems. The unique design provides high flow above the desired setpoint.

This brass regulator provides high flow during cryogenic vessel pressure build function and increased sensitivity to downstream pressure changes as a function of this unique valve. The unique diaphragm gives increased performance and pressure stability.

The brass GDR Series Regulator provides reliable and precise pressure control in the most demanding applications. A high flow fully balanced regulator with extremely low droop characteristics that virtually eliminates outlet pressure fluctuations due to inlet pressure variations.

These MV manual gas control valves are optimised for the demanding requirements of gas cylinder fill plants, manifolds, and piping system applications. Available in a variety of porting and mounting configurations including a panel mount option for your preferred install.

These MVA Pneumatically Actuated High Pressure Gas Control Valves are optimized for the demanding requirements of Automated Gas Cylinder Fill Plants, Manifold, and Piping System applications. The normally closed version seals bubble-tight up to an inlet pressure of 5500 PSI with only 85 PSI required to open the valve to full orifice.

Brass, 303 and 316 stainless bar stock screwed bonnet options are suitable to a MAWP of 5,000psi. These low cost, soft or metal seated, 1/8” to 1/2” valves can be ordered, cleaned and packaged for oxygen service.

Series FNV and Series FNV ML Stainless Needle Valves feature a forged body, integral bonnet design with PTFE and metallic wafer stem packing. This provides long-life, leak-tite service from vacuum to the maximum operating pressure.

These high pressure, one-piece body brass and stainless steel valve with zero leakage is suitable to a MAWP of 10,000psi. The unique design features a fully retained encapsulated O-ring seal with metal to metal backup for prolonged service life.